BBA_CORR_POL=0, DCOC_CORRECT_EN=0, DCOC_MIDPWR_TRK_DIS=0, TRACK_FROM_ZERO=0, TZA_CORR_POL=0, DCOC_TRK_EST_OVR=0, DCOC_CORRECT_SRC=0
DCOC Control 0
| DCOC_MIDPWR_TRK_DIS | DCOC Mid Power Tracking Disable 0 (0): Tracking corrections are enabled as determined by DCOC_CORRECT_SRC and DCOC_TRK_MIN_AGC_IDX. 1 (1): Tracking corrections are disabled when either the TZA or BBA lo peak detector asserts. |
| DCOC_MAN | DCOC Manual Override |
| DCOC_TRK_EST_OVR | Override for the DCOC tracking estimator 0 (0): The tracking estimator is enabled only as needed by the corrector 1 (1): The tracking estimator remains enabled whenever the DCOC is active |
| DCOC_CORRECT_SRC | DCOC Corrector Source 0 (0): If correction is enabled, the DCOC will use only the DCOC calibration table to correct the DC offset. 1 (1): If correction is enabled, the DCOC will use the DCOC calibration table and then the tracking estimator to correct the DC offset. |
| DCOC_CORRECT_EN | DCOC Correction Enable 0 (0): Correction disabled. The DCOC will not correct the DC offset. 1 (1): Correction enabled. The DCOC will use the TZA and BBA DACs, and apply digital corrections (if DCOC_CORRECT_SRC=1) to correct the DC offset. |
| TRACK_FROM_ZERO | Track from Zero 0 (0): Track from current I/Q sample. 1 (1): Track from zero. |
| BBA_CORR_POL | BBA Correction Polarity 0 (0): Normal polarity. 1 (1): Negative polarity. This should be set if the ADC output is inverted, or if the BBA DACs were implemented with negative polarity. |
| TZA_CORR_POL | TZA Correction Polarity 0 (0): Normal polarity. 1 (1): Negative polarity. This should be set if the ADC output is inverted, or if the TZA DACs were implemented with negative polarity. |
| DCOC_CAL_DURATION | DCOC Calibration Duration |
| DCOC_CORR_DLY | DCOC Correction Delay |
| DCOC_CORR_HOLD_TIME | DCOC Correction Hold Time 127 (127): The DC correction is not frozen. |